Block paving sealers and driveway sealers
Expert advice - Knowledge - How to seal - Buy direct

Premium Block paving sealer

Trade grade - use what the trade use

The latest high quality tough acrylic co-polymer resin, suspended in our unique blend of organic solvents

Designed to protect block paved areas by repelling water, dirt, oil and fuels Inhibits algae, weed and moss growth

Bonds jointing sand

USE
Ready to use for sealing porous cement made block paving
(not for use on clay block paving)

EFFECT
Colour enhancement (damp look when dry)

SURFACE FINISH
2 coat application - Matt/ silk
3 coat application - Sheen

SPREADING RATE

More if surface has been previously sealed

DRYING TIME
Dry to walk on usually within 2hr - During normal temps Lower temps will extend drying time
Recoat when dry enough to walk on (1-2hr) no-longer tacky
Do not park vehicles on surface for 48 hrs

PREPARATION
Apply above 5°C. Do not apply to wet/ damp surfaces, if rain is imminent, damp atmosphere. If efflorescence is present (White staining on blocks from new).

New blocks
Apply as soon as possible after installation. Ensure surface is clean, dry and remove excess sand. Ensure jointing sand is dry.

Old blocks
Fully clean off surfaces with power wash, apply Premium weed and moss inhibitor. Allow to dry thoroughly and brush in dry jointing sand prior to sealer application.

APPLICATION
Always complete a test area
By course droplet low level (solvent resistant) sealer sprayer, brush, broom or roller.
Brush out excess pooling and avoid over coating.

CLEANING
For cleaning equipment use SD Thinners. (Not White Spirit)

PRECAUTIONS
Flammable. Keep away from sources of ignition High VOC - Do not breathe vapour or spray
Do not eat, drink, or smoke when using

Ensure good ventilation during application
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Remove splashes from the skin with a recognized hand cleaner Keep out of reach of children
Do not use near fishponds Toxic to aquatic organisms
May cause long term adverse effects in the aquatic environments

The specification and coverage rates are given in good faith and are based on our experience and knowledge but without liability

As Sealers Direct has no direct control over the methods employed by the user in applying its products, any warranty either written or implied is given in good faith and can only cover the material itself

If in doubt regarding any of the above points please contact us
A Material Safety Data Sheet is available on request
admin@sealersdirect.co.uk
www.sealersdirect.co.uk
Technical information or advice call: Nigel 07899 748333