Made in Britain logo
Trading Standards Approved logo

SEALERS DIRECT LTD

Paving sealer and driveway sealers serving the UK since 1980
Buy direct from the factory
01202 620 377
07899 748 333
payment options
0

Eco HD Roof tile sealer data sheet

Eco HD Roof tile sealer clear  - (heavy duty)

A safe SOLVENT FREE roof tile sealer, environmentally friendly

Our top of the range, tough single part, advanced cross linking acrylic co-polymer resin

Protects against frost and reduces surface deterioration
Inhibits moss, algae, lichen and fungus growth
Allows moisture vapour to escape (breath)

USE – weather proofing & sealing porous roof tiles

COLOUR
Milky in appearance and becomes clear as product dries.

SURFACE FINISH
Virtually no colour enhancement (dry look)
Matt: 1 coat
Cures clear

SPREADING RATE
Depending on surface type, porosity and application method Minimum 2 coats for best results
6 m2 per litre 1 coat (approx)

DRYING TIME
Dry usually within 2hr - During normal temps’ 10˚C+ Lower temps and areas in the shade will extend drying time
Full cure approximately 3-7 days

PREPARATION
Allways complete a test area
All surfaces must be clean, dry and be free from loose and flaking material, dust, dirt, grease and vegetative growth.

APPLICATION
heavy droplet low level spray, broom, brush or roller
*Avoid over flooding surface
* Brush out pooled sealer
Do not leave pooled sealer to cure

CLEANING - For cleaning equipment use water & detergent

PRECAUTIONS
Wear gloves and eye protection
In case of contact with eyes, rinse immediately with water and seek medical advice Remove splashes from the skin with soap and water
Keep out of reach of children

GENERAL INFORMATION
ODOURLESS NON FLAMMABLE
NON HAZARDOUS 0 VOC’S
Do not use below 8˚C. Protect stored product from frost and freezing Do not seal wet or damp surfaces
Do not start sealing if rain is imminent

Do not use chlorine, bleach, sodium hypochlorite, acid, Paveclear or Paveclean chemicals prior to sealing with Eco HD

The specification and coverage rates are given in good faith and are based on our experience and knowledge but without liability

As Sealers Direct has no direct control over the methods employed by the user in applying its products, any warranty either written or implied is given in good faith and can only cover the material itself

If in doubt regarding any of the above points please contact us A Material Safety Data Sheet is available on request
admin@sealersdirect.co.uk
www.sealersdirect.co.uk
Technical information or advice call: Nigel 07899 748333
Share by: